Edge Lighting Cirrus Channel, Wall Wash Lens - Manual (Page 3)

3
G
SURFACE
NOTE:
if mounting the clips to a wood surface directly.
Steps 4 and 5 are for drywall mounting. Omit these steps
4: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
5: Screw in the threaded portion of the anchors with a Phillips
screwdriver. 4
5
ANCHOR
ANCHOR MUST
BE FLUSH TO WALL
I
MOUNTING
CLIP (C-MCL)
LOCKING CLIP
7
7: Line up the locking clips & mounting clips to anchor holes
and secure them by tightening the two #6 screws with
washers under the head into each clip.
#6 SCREW &
WASHER
7
J
MOUNTING
CLIP (C-MCL)
LOCKING CLIP
8: Connect the red power supply (24VDC+) wire to red strip
wire with a wire nut inside the electrical box.
9: Connect the black power supply (24VDC+) wire to black
strip wire with a wire nut inside the electrical box.
10: Snap the wire management clip to hold the cable in place if
necessary.
7
WIRE
MANAGEMENT
CLIP
CORD
CHANNEL
10
H
6: If using the standard Junction box only, mount the
crossbar to the electrical box holes with the two #8-32
screws provided.
#8-32 SCREW
CROSSBAR
6
6
8
9
JUNCTION BOX