Edge Lighting Night Owl LED User Manual
Night owl, Install the fixture, Installation instructions for
- This product is ETL listed for indoor locations.
- This product is for wall mount application.
- This instruction shows a typical installation for indoor.
Installation Instructions for
Night Owl
904-NIGHTOWL-C-04
Install the Fixture
NIGHTOWL-C-_
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
A
1: Loosen
and bottom of the canopy with the 1.5mm Allen wrench
provided. Carefully remove the crossbar.
(Do Not Remove) the two M3 set screws on top
CROSSBAR
1.5MM ALLEN WRENCH
M3 SET SCREW
LED DRIVER
B
CANOPY
2: Line up the crossbar slots with the electrical box holes, and
secure it in place by tightening the two #8-32 screws
provided.
CROSSBAR
#8-32 SCREW
ELECTRICAL
BOX HOLE
1
1
2
2
LOW VOLTAGE
WIRES
POWER 120 VOLT
WIRES (240 VOLT EUROPE)
PRIMARY
120 VOLT WIRES
(240 VOLT EUROPE)
© 2011 Edge Lighting. All Rights Reserved.
1
NOTE:
The fixture contains a 1 Watt integrated LED lamp. This
lamp is rated for 50,000 hours.
3: Connect the LED driver white primary wire to the neutral
power wire with a wire nut.
4: Connect the LED driver black primary wire to the hot power
wire with a wire nut.
4
3
5: Place the LED driver and wires inside the electrical box.
6: Slide the canopy onto the crossbar and secure it in place by
tightening the two M3 set screws with the 1.5mm Allen
wrench.
D
M3 SET SCREW
1.5MM ALLEN
WRENCH
6
5
7: Use the switch to control the lamp intensity.
CANOPY
LOW VOLTAGE
WIRES
PRIMARY WIRES
LED DRIVER
POWER WIRES
6
SWITCH
7