Edge Lighting Garbo User Manual
Garbo wall, Install the fixture, Installation instructions for
SAVE THESE INSTRUCTIONS!
GARBO-W-25-F1-_
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only, either vertically or
horizontally.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- Only the GARBO-W-25-F1D-_ models are dimmable with a
standard incandescent dimmer. The GARBO-W-25-F1-_
models are not dimmable.
Installation Instructions for
Garbo Wall
904-GARBO-W-F1-04
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
Install the Fixture
1:
the fixture to remove the crossbar.
Loosen and remove the two Phillips screws in the center of
1
A
PHILLIPS SCREW
#8-32 SCREW
CROSSBAR
B
2 Feed the power wires through the crossbar center cutout.
3: Mount the crossbar to the electrical box holes with the
provided #8-32 screws.
:
3
ELECTRICAL
BOX HOLE
3
CANOPY
CROSSBAR
4: Make sure that the crossbar is grounded in accordance with
local electrical codes.
5: While holding the fixture, connect the white fixture wire to
the neutral power wire with a wire nut.
6: Connect the black fixture wire to the hot power wire with a
wire nut.
C
CANOPY
4
6
5
FIXTURE
CROSSBAR
1
1
2
GARBO-W-25-F1D-_
© 2012 Edge Lighting. All Rights Reserved.