Edge Lighting Sun3C Ceiling LED Downlight Components - Indoor/Outdoor - Manual (Page 2)

10
10
COVER
#8-32
SCREW
D
9: Slide the housing to desired position. If necessary loosen the
wing nuts to ease the sliding. After the desired position is
achieved tighten all the wing nuts.
9
9
10: Loosen the four #8-32 screws on the front of the housing,
to remove the cover.
11: Remove a knock out to install the power line conduit.
12: Install the conduit and run the power line wires to the
housing.
13: Make sure that the housing is grounded in accordance
with local electrical codes.
14: Connect the white LED power supply wire to the neutral
power line wire with a wire nut.
15: Connect the black LED power supply wire to the hot power
line wire with a wire nut.
LED POWER
SUPPLY
F
13
11
2
E
16: Feed the black & red output wires from the LED driver
along with the tether through the cover hole. Mount the
cover to the housing with the four #8-32 screws. The hole
should be over the tether and the solid side will
cover the LED driver.
G
COVER
OPENING
#8-32
SCREW
10
16
14
15
WING NUT
HOUSING