Edge Lighting Port LED Components - Manual

SAVE THESE INSTRUCTIONS!
- The Spring Clips (SC-WO) are an accessory that are used
with Sun3 and Port fixtures. When they are installed in a
porch wood surface.
Installation Instructions for
Sun 3 & Port Spring Clips
904-SC-WO-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
1
© 2011 Edge Lighting. All Rights Reserved.
SC-WO
Install the Spring Clips
A
1: Remove the two Phillip screws from the bottom of the
fixture trim tab.
NOTE:
underground cables and outdoor rated wire nuts when no conduit
is used to power the fixture(s).
For outdoor installation, use UL listed type UF
SPRING CLIP
B
1: Mark a point on the surface where the fixture opening is
going to be located.
2: Cut out the marked location with a 2-7/8" circular saw for
SUN3 or a 2" circular saw for Port fixture.
MOUNTING HOLE
IDENTIFICATION
SUN3 HOLE
PORT HOLE
FIXTURE
TRIM TAB
PHILLIPS SCREW
2
2
Installation Preparations
NOTE:
provided with each fixture.
For detailed wiring information refer to the instructions
2 or 2 7/8"
HOLE
SURFACE
NOTE:
the outer hole is to be used with Sun3 fixture.
The inner hole on spring clip is to be used with Port and
700mA
120V NEUTRAL (WHITE)
120V HOT (BLACK)
POWER
SUPPLY
-
+
Wiring Diagram
FIXTURE
2:
diagram for clarification) with the trim tab hole. Replace and
tighten the Phillips screw. Before installing fixture,
slightly rotate the spring clips towards each other to
make it easier to install (refer to the drawing). For each spring clip, align one of the two holes (refer to
2
TURN SPRING CLIPS
TOWARD EACH
OTHER BEFORE
INSTALLATION
SPRING CLIP
FIXTURE
2