Edge Lighting Vanilla Sky Square - Manual (Page 2)

SQUARE GLASS SHADE
2
1
2
SPRING CLIP
D
THUMB NUT
THREADED
STUD
ELECTRICAL
BOX
CEILING
6
7
2
Install the Lamp & Glass Shade
6: Place all wires and wire nuts connections inside electrical box.
7: Align and push the canopy holes onto threaded studs and
tighten the thumb nuts completely to secure the canopy in
place.
F
SQUARE GLASS SHADE
2
1: Push the lamp pins completely into the socket holes.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 9 Watt Type 2G7 Base Compact
Fluorescent Lamp For Each Socket.
E
LAMP
SOCKET
1
1
2
2
SPRING CLIP
2: Place the two adjacent edges of the square glass shade into
two adjacent spring clips. Slightly push the glass shade
against these two spring clips and simultaneously slide the
other two edges into the other two spring clips. Make sure
all four edges of the glass shade sit properly into four
spring clips.
1: While holding the glass shade unhook one spring clip at a
time until the glass shade is free.
2: Remove the old lamp and then follow "Install the Lamp &
Glass Shade" steps to complete lamp replacement.
Replace the Lamp
G