Edge Lighting Mint Square - Manual

SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is ceiling mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
Installation Instructions for
Mint 5 Square
904-MINT-5-SQ-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2010 Edge Lighting. All Rights Reserved.
IMPORTANT SAFETY INSTRUCTIONS
Install the Fixture
1: Loosen the two M4 set screws on the
backplate with the 2mm Allen wrench provided.
2: Carefully pull the glass shade out.
(DO NOT REMOVE)
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shade provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
2
1
A
GLASS SHADE
B
MINT-5-C-SQ-FR-_
BACKPLATE
M4 SET
SCREW
1 1
5
3
4
3: Make sure that the fixture is grounded in accordance with
local electrical codes.
4: Connect the white fixture wire to the neutral power wire
with a wire nut.
5: Connect the black fixture wire to the hot power wire with a
wire nut.
ELECTRICAL
BOX
BACKPLATE
2MM ALLEN
WRENCH