Bc d – Edge Lighting PSB-2X100W-ELV-24VDC, 2x96 Watt 24 Volt DC Power Supply User Manual
Page 2
2
3
2: Install power supply enclosure and ELV dimmer as required. Ensure that power supply enclosure is grounded in accordance
with local electrical code.
3: Connect 120VAC hot and neutral wires from panel to the ELV dimmer using wire nuts.
4: Remove knockouts from power supply enclosures as required. Route 120VAC hot and neutral wires from the ELV dimmer to
power supply enclosure.
POWER SUPPLY 1
POWER SUPPLY 2
5: Connect the 120VAC hot wire from the dimmer to both black
transformer wires using a wire nut.
6: Connect the 120VAC neutral wire from the dimmer to both
white transformer wires using a wire nut.
7: Connect the ground wires from the each power supply to the
case ground wire using a wire nut.
POWER SUPPLY 1
POWER SUPPLY 2
NOTE:
Use only 24 volt LED soft strip with this power supply.
8: Connect the red (24V DC+) wire from Power Supply 1 to the
red wire of a four-pin power connector with a wire nut.
9: Connect the black (24V DC-) wire from Power Supply 1 to
the black wire of a four-pin power connector with a wire nut.
10: Repeat steps 8 and 9 to connect a four-pin power
connector to Power Supply 2.
2
2
3
3
4
ELV DIMMER
120 VAC NEU
120 VAC HOT
6
5
7
8
9
10
10
FOUR-PIN
POWER
CONNECTORS
CASE
B
C
D