Edge Lighting PSB-100W-ELV-24VDC, 96 Watt 24 Volt DC Power Supply - Manual (Page 2)

2
C
LED SOFT STRIP
8: Use the "Low Voltage Wire Size Chart" below to determine
the proper wire size connecting the power supply wires to
the LED soft strip wires.
NOTE: Maximum length of a single soft strip to be connected to
the power supply is 40' of SS2C, SS2P, SS3, or SS1. For parallel
strip connections, do not exceed 32' total length.
NOTE: Use only 24 volt LED soft strip with this power supply.
9: Connect the red (24V DC+) power supply wire to the red
wire of each LED soft strip with a wire nut.
10: Connect the black (24V DC-) power supply wire to the black
wire of each LED soft strip with a wire nut.
11: Replace the power supply cover and tighten the four
Phillips screws on top of the cover.
12: Connect the 120 volt power wires at the panel.
13: Turn on the power.
NOTE: In order to use small gauge wires from the power
supply to the LED fixture, it is recommended to install the power
supply as near as possible to the LED fixture. See "Low Voltage
Wire Size Chart" below.
Overall Wiring Diagram
BLACK
LED SOFT STRIP
RED
BLACK
PSB-100W-ELV-24VDC
24V DC+
24V DC-
ELV DIMMER
WHITE
NEUTRAL
120V INPUT
10
HOT (INPUT)
HOT (OUTPUT)
LOW VOLTAGE WIRE SIZE CHART
TRANSFORMER
VOLTAGE
WIRE SIZE
UP TO 48 FT
WIRE SIZE
FOR 49-65 FT
WIRE SIZE
FOR 66-107 FT
24 Volt #14 GA #12 GA #10 GA
9
24VDC NEG
24VDC POS
D
PHILLIPS
SCREW
LED SOFT STRIP
COVER