Edge Lighting PSB-60W-ELV-24VDC, 60 Watt LED 24 Volt DC Power Supply - Manual

PSB-60W-ELV-24VDC
Installation Instructions for 24 Volt DC Power Supply
1
904-PSB-60W-ELV-24VDC-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
SAVE THESE INSTRUCTIONS!
- Do not install this power supply in a wet location.
- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
- Do not install *LED fixture closer than three inches or as
specified in the *LED fixture installation instructions to
curtains or similarly combustible materials. Keep insulation
at least 3" away from the enclosure.
- Turn the electrical power off before modifying the lighting
system in any way.
- The system is "UL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.
- For dimming options refer to EDGELIGHTING.COM.
* See LED fixture installation instructions for proper
placement.
- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions "
before installation.
- This product is not suitable for wet locations. It is approved
for the use at any height above the finished floor.
- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.
- TO REDUCE RISK OF FIRE, it is important to wire the
power supply for the system as described in this
installation instruction.
GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS
© 2013 Edge Lighting. All Rights Reserved.
Install the Power supply
A 1: Loosen and remove the four Phillips screws on the top of
the power supply to remove the cover.
2: Secure the power supply case to the desired location with
the four #6 screws provided.
PHILLIPS
SCREW
B
3: Install a conduit and power wires from the panel to the
power supply.
4: DO NOT connect the power wires to the panel at this time.
5: Ground the power supply housing in accordance with local
electrical codes.
6: Connect the 120 volt hot black wire coming from the power
supply switch to the hot power wire with a wire nut.
120V NEUTRAL
CONDUIT
120V HOT
6
TRANSFORMER
NOTE: The bottom white wire coming from the switch is for the
switch light. If not using the switch light, cap the wire with a
wire nut.
7: Connect the 120 volt neutral wire to the white (wraped in
black heat shink) wire coming from the transformer and to
the white wire coming from the power supply switch
(optional) with a wire nut.
COVER
1 1
1
1
2
#6 SCREW
POWER
SUPPLY CASE
3
5
7
E360941