Edge Lighting Cirrus Channel Suspension, Direct 1" Lens User Manual

Page 3

STANDOFF
POST TAB

AIRCRAFT
CABLE

8: Push the tab on standoff while feeding the aircraft cable
coming from the channel into a standoff so that it holds one
end of the fixture in place.

#8 SCREW

WASHER
W/THREADED
NIPPLE

STANDOFF
POST

WASHER
W/THREADED
NIPPLE

5: Feed the #8 screw through the washer w/threaded
nipple into the anchor.

6: Tighten the #8 screw completely into the anchor.

7: Tighten the standoff posts completely onto the threaded
nipple.

9: Feed the coaxial cable through the power feed canopy.

CONNECTOR
ASSEMBLY

COAXIAL
CONNECTOR
COVER

12: Unscrew the coaxial connector covers and remove from the
connector assembly.

NOTE: If cable is curled or kinked, straighten by holding
between the shaft of a screwdriver and thumb and pulling the
cable through (see inset K1)

1.5MM ALLEN WRENCH

2MM ALLEN
WRENCH

M4 SET
SCREW

M3 SET
SCREW

13: Using the provided 1.5mm Allen Wrench, remove the M3
set screw from the coaxial connector assembly.

14: Using the provided 2mm Allen wrench to loosen (do not
remove) the M4 set screw.

10: Using the 18 AWG hole of the wire strippers, remove 1" of
the outer braided wire.

11: Using the 20 AWG hole of the wire strippers, remove 1/8"
of inner plastic insulation from the end of the coaxial cable.

BRAIDED
WIRE

INNER
INSULATION

BARE WIRE

1/8"

COAXIAL CABLE

WIRE STRIPPERS

COAXIAL
CABLE

POWER
CANOPY