Edge Lighting Fast Jack Multi-Port Canopies Without Transformers User Manual
26" rectangle 2 & 3 port fast jack canopy only, Install the canopy, Installation instructions for

SAVE THESE INSTRUCTIONS!
FJC-26RE-_
- This product is ETL listed for indoor dry locations.
Installation Instructions for
26" Rectangle 2 & 3 Port Fast Jack
Canopy Only
1
904-FJC-26RE-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2012 Edge Lighting. All Rights Reserved.
Running the Power from a Remote Transformer to the
Fast Jack Canopy
A
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.
REMOTE
TRANSFORMER
ELECTRICAL BOX
CONDUIT
MAX
20FT
FAST JACK
CANOPY
1
Install the Canopy
B
PHILLIPS SCREW
1
1
MOUNTING PLATE
CANOPY
1
1: Loosen and remove the six Phillips screws from the canopy
to remove the mounting plate.
C
MOUNTING PLATE
ELECTRICAL BOX HOLE
2
2
2 Align the mounting plate holes with the electrical box holes
and mark a point through the mounting plate holes onto the
ceiling. These points are used for the anchors.
:
D
3
4
ANCHOR
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.