Edge Lighting 12" Fast Jack Canopies Without Transformers - Manual

SAVE THESE INSTRUCTIONS!
FJC-12RD-_
- This product is ETL listed for indoor dry locations.
B
1: Loosen and remove the three #8-32 screws from the canopy
to remove the mounting plate.
Installation Instructions for 12" Round 3 & 4 Port Fast Jack
Canopy Only
1
904-FJC-12RD-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
#8-32 SCREW
1 1
MOUNTING PLATE
CANOPY
© 2012 Edge Lighting. All Rights Reserved.
Running the Power from a Remote Transformer to the
Fast Jack Canopy
A
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer. REMOTE
TRANSFORMER
ELECTRICAL BOX
CONDUIT
MAX
20FT
FAST JACK
CANOPY
1
Install the Canopy
MOUNTING
PLATE
ELECTRICAL BOX
2
C
#8-32
SCREW
2: Feed the low voltage coming from the remote transformer
through mounting plate center hole.
3: Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
2
3