Edge Lighting 2x250W/12V Surface Mount Magnetic Transformer - Manual (Page 5)

5
POWER FEED ROD
2
N
1: Remove the wire nuts from the center wires.
2: Loosen (DO NOT REMOVE) the bottom M3 set screw on
the bushing and carefully pull out the power feed rod along
with the center wire.
Shortening the Power Feed Rod Height
M3 SET
SCREW
1.5MM ALLEN
WRENCH
BUSHING
POWER FEED ROD
O
3: From the end of the power feed rod mark the rod to the
amount that needs to be shorten. For example to resize 24"
standoff to 17", mark 7" from the end of the power feed rod.
3
POWER FEED ROD
P
4
4: Use a pipe cutter to cut out the excess rod.
PIPE CUTTER
POWER HOUSING
Q
5: Feed the center wire through the bushing inserting the
power feed rod completely inside the bushing. Tighten
the bottom M3 set screw with the 1.5mm Allen wrench.
6: Connect the center wire to the loose transformer wire with a
wire nut.
7: Follow the "Install the Surface Mount Transformer" steps on
page 2.
POWER FEED CAP
1
POWER FEED ROD
5
M3 SET
SCREW
1.5MM ALLEN
WRENCH
BUSHING
6