Edge Lighting 300W/24V Surface Mount Magnetic Transformer - Manual (Page 4)

4
Install the Monorail(s) to the Transformer
I
STRAIGHT
CONDUCTIVE
CONNECTOR
1
ONE MONORAIL SECTION
MONORAIL FEED CONTACT
SURFACE TRANSFORMER
3
2
MONORAIL
SECTION
NOTE:
connecting the Monorail to the transformer (refer to the
instructions provided with the Monorail 1" standoffs).
The Monorail 1" standoffs should be installed before
1: Push one end of the straight conductive connectors
(provided with the transformer) completely into one end of
the Monorail section.
2: Push the end of the straight conductive connectors (along
with the Monorail) completely into one Monorail feed
contact. While supporting the Monorail section by hand
connect this section to the Monorail 1" standoffs (refer to the
instructions provided with the Monorail 1" standoffs).
3: If using second Monorail section, then repeat steps 1 & 2.
NOTE:
together by the Monorail feed contacts.
The two Monorail sections are electrically connected
J
4: If using only one Monorail section then plug the unused
Monorail feed contact with the plastic insert provided.
MONORAIL FEED CONTACT
PLASTIC
INSERT
SECOND MONORAIL
SECTION
4