Edge Lighting 2 Circuit Standoffs - Sloped Ceiling - Manual

C
M3 SET SCREW
1.5MM ALLEN
WRENCH
THREADED
POST
1
#8 SCREW
INTEGRATED
WASHER-NIPPLE
ANCHOR
4
M2S-SL-_
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail 2 Circuit systems only.
- Use Monorail 2 Circuit standoffs where the Monorail 2
Circuit sections join together and approximately every 3
feet max throughout the Monorail run.
Monorail 2 Circuit Sloped Ceiling Standoffs Installation Instructions for
904-M2S-SL-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
A
Install the Standoff Hardware
1: Hold the Monorail 2 circuit section against the ceiling or use
a plumb bob to mark the sloped standoff locations onto the
ceiling (this may require more than one person).
2: Tap the anchors onto the marked locations up to the
threaded portion with a hammer.
3: Screw the threaded portion of the anchors in with a Phillips
screwdriver.
ANCHOR
CEILING
2
B
4: Mount the integrated washer-nipple to the anchor with the
#8 screw provided.
5: Tighten the threaded post completely onto the integrated
washer-nipple.
1: Push the sloped standoff connector completely into the
threaded post and tighten the M3 set screw with the 1.5mm
Allen wrench.
SAVE THESE INSTRUCTIONS!
3
THREADED POST
5
Sloped Standoff Connector
Power Feed Canopies Installation for Monorail 2 Circuit
1
SLOPED STANDOFF
CONNECTOR
© 2009 Edge Lighting. All Rights Reserved.