Edge Lighting Scope LED Pendant - Manual (Page 3)

H
METAL SHADE
I
3
Adjusting the Light Beam & Intensity
1: Rotate the lens housing (inside the fixture body) and set the
beam spread to either spot or flood.
NOTE: The Scope LED head consumes 10 watts and contains
integrated LED lamps which are rated for 50,000 hours.
LENS
HOUSING
1
LENS HOUSING
LENS
HOUSING RING
ALLEN WRENCH
SOFT FOCUS FILM
PMMA LENS
2
NOTE: For 15% to 20% more light output, the soft focus film can
be removed, however the corners of the beam will have sharp
edge. Omit these steps if not adjusting the light output.
2: Use a small Allen wrench or a pen point to loosen the lens
housing ring.
3: Remove the lens housing ring, the soft focus film and the
PMMA lens. Please save these items for future use.
NOTE: To reinstall the soft focus film, place the PMMA lens
followed by the soft focus film and the lens housing ring. Tighten
the ring with the small Allen wrench or pen point to hold the
assembly in place.
Install the Crystal Accessory
K
1: Squeeze the crystal accessory spring ends and carefully push
it into the metal shade.
METAL SHADE NOTE: Make all necessary adjustment to fixture, before
crystal accessory (sold separately) is installed.
CRYSTAL
SPRING
ACCESSORY
1
1