Edge Lighting King's Crossing - Manual (Page 2)

C
3: Place the crystal body onto the housing post assembly and
secure it in place by tightening the cap nut.
D
HOUSING POST
ASSEMBLY
CRYSTAL BODY
CAP NUT WITH
HANGING CRYSTAL
3
3
4: Remove one pin screw from the housing post.
5: Insert the two housing post with pin screws into the two
glass shade holes.
6: Align the third housing post with the third glass shade hole
and secure it in place by tightening the pin screw to the
housng post.
4
PIN
SCREW
GLASS SHADE
PIN SCREW
HOUSING
POST
ASSEMBLY
2
5
6
F
M4 SET SCREW M3 SET
SCREW
1.5MM ALLEN
WRENCH 2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE CONNECTOR
Adjust the Fixture Height
E
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the glass shade to the end of the coaxial cable.
H
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
1
HOUSING POST