Edge Lighting Neo Pro Aim MR16 User Manual
Page 3

3
Install the Neo to Monorail 2 Circuit Connector (M2C-FJ-_)
MONORAIL 2 CIRCUIT
FAST JACK HOUSING
HOUSING
CONNECTOR
(DISCARD)
1
H
1: Remove the Monorail 2 Circuit housing connector from the
Monorail 2 Circuit Fast Jack housing and discard it.
2: Place the Monorail 2 Circuit Fast Jack housing onto the
Monorail 2 Circuit and use fingers to tighten the Neo housing
connector to the Fast Jack housing. Make sure that the
Neo housing connector is not cross threaded.
I
1
MONORAIL 2 CIRCUIT
MONORAIL 2 CIRCUIT
FAST JACK HOUSING
NEO HOUSING
CONNECTOR
1
J
#4-40 SET
SCREW
0.05 ALLEN
WRENCH
3
4
CIRCUIT #1
CIRCUIT #2
1
2
N
1
2
N
3: To power the Neo from circuit #1, top and bottom
(neutral) rails, tighten the #4-40 set screw on top of the
housing with the 0.05 Allen wrench. Make sure this set
screw connection is very tight.
4: To power the fixture from circuit #2, middle and bottom
(neutral) rails, remove the #4-40 set screw from top of the
housing and tighten it into the side threaded hole with the
0.05 Allen wrench. Make sure this set screw connection
is very tight.
NOTE:
set screw to select a circuit on the Monorail 2 Circuit connector.
To avoid shorting the system, do not use more than one
NOTE:
Do not load either circuit over the maximum system
rating.
2
Install the Fixture to Fast Jack Canopy (FJP-2SQ-_, FJP-4SQ-_,
FJP-4RD-_)
K
1: Loosen the top M4 set screw on the Neo arm with the 2MM
Allen driver.
2: Remove and discard the Neo housing connector.
FAST JACK CANOPY
CONNECTOR
FAST JACK FIXTURE
CONNECTOR
L
3
4
3: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack canopy connector.
4: Tighten the top M4 set screw with the 2mm Allen driver to
secure the fixture in place.
2MM ALLEN
DRIVER
TOP M4 SET
SCREW
TOP M4 SET
SCREW
2MM ALLEN
DRIVER
NEO HOUSING
CONNECTOR
(DISCARD)
1