Bio-Rad S1000™ Thermal Cycler - Manual (Page 32)

S1000 Thermal Cycler Manual
23
6 Maintenance and
Troubleshooting
Read this chapter for information on maintaining the S1000™ thermal cycler and
troubleshooting problems on the thermal cycler.
• Cleaning and maintaining the S1000 thermal cycler (page 23)
• Maintaining sufficient airflow (page 25)
• Replacing fuses (page 26)
Cleaning and Maintaining the S1000 Thermal Cycler
The S1000 thermal cycler requires little maintenance for proper operation and precise thermal
control. However, with long and constant use, the thermal cycler requires some cleaning and
other maintenance. Information on cleaning the thermal cycler base and reaction module is
included in this chapter. In addition, instructions on replacing the fuses are provided.
Cleaning the S1000 Thermal Cycler
The S1000 thermal cycler should be cleaned on a regular schedule to remove any debris or dirt
that might interfere with proper function. Clean the base to prevent damage to the air intake or
reaction module bay.
NOTE: For instructions on handling and cleaning radioactive or biohazardous
materials, consult the guidelines for radiation safety and biosafety provided by your
institution. These guidelines include cleaning, monitoring, and disposal methods
for hazardous materials.
To clean the thermal cycler base, follow the instructions below, paying careful attention to the
warnings:
WARNING! To prevent electrical shock, always turn off and unplug the instrument
before cleaning it.
• Clean the air vents. Remove dust with a soft brush, damp cloth, or vacuum cleaner.
Remove any heavy dust that is deep in the vents with a vacuum cleaner. Cleaning the
vents allows sufficient airflow for precise thermal control during a run
• Clean the control panel. Remove debris on the control panel with a soft cloth and mild
soap solution. Cleaning the panel prevents debris that may obscure the display