8 – manual operations, Manually running a program, Forcing a program to start – Baseline Systems BaseStation 3200 User Manual
Page 73: Stopping an active program

BaseStation 3200 Advanced Irrigation Controller Manual
8 – MANUAL OPERATIONS
The BaseStation 3200 has several options that enable you to manually control your irrigation system. You can force
a program to start, stop a program that is actively watering or set the next start date for a program.
You can also manually water a single zone, all zones, or the zones of a program. The Manual Water is useful for
doing a walk-about test of multiple valves, or for applying additional water for a short period of time to a specific
zone.
Manually Running a Program
Manual Run is used to force a program to start, stop a program that is actively watering, or set the NEXT start date
for a program when you are using the Historical ET Calendar interval setting.
Note: Programs that do not use the Historical ET Calendar mode have a fixed schedule and are modified in the Day
Intervals dial position. Refer to the topic for setting up the day intervals for a program on page 49.
Forcing a Program to Start
1. Turn the dial to the Manual Run Program position.
2. Make sure that the field at the top of the screen says Start or Stop
Program. If another option displays in that field, press the + button to
change the option to Start or Stop Program.
3. Press the NEXT button to move to the list of programs.
4. Press the NEXT button to move to a stopped program that you want to
start.
5. Press the + button to change the program’s status to Running.
6. Turn the dial to the Auto Run position.
Stopping an Active Program
1. Turn the dial to the Manual Run Program position.
2. Make sure that the field at the top of the screen says Start or Stop Program. If another option displays in that
field, press the + button to change the option to Start or Stop Program.
3. Press the NEXT button to move to the list of programs.
4. Press the NEXT button to move to a running program that you want to stop.
5. Press the + button to change the program’s status to Stopped.
6. Turn the dial to the Auto Run position.
Page
65