Great Plains 3N-4025P Operator Manual - Manual (Page 85)

Great Plains Manufacturing, Inc. Table of Contents Index Adjustments 81
2014-01-29 Table of Contents Index 196-538M
Refer to Figure 103
3.
Pry the seed meter wheel out about
1 ⁄
4
inch (6 mm)
using the tool stored under the walkboard, and spin
backward to clean out seeds from top pockets.
Note: If wheel is not free of all seed, wheel removal is
much more difficult, as pocketed seeds will shear
against meter parts.
Refer to Figure 104
4.
Remove seed meter wheel.
Refer to Figure 105
Note: With the seed meter wheel removed, you may want
to check the meter for internal damage or trash.
Note: Some wear on top edge of slide is normal.
Excess wear is cause for replacement.
5. Place new wheel on meter wheel shaft. Tilt it slightly
forward to engage and push back on the slide. Seat
wheel fully on cross-pin.
6. Replace spring-loaded wheel retainer. Make
1 ⁄
4
turn
to seat cross-pin in shallow groove of retainer.
Figure 103: 10HD, 25P:
Pry Meter Wheel
22913
Figure 104: 10HD, 25P:
Remove Wheel
25274
Figure 105: 10HD, 25P:
Inspect Meter
22884
1
1