Great Plains NTA3007 Operator Manual - Manual (Page 83)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 79
2012-07-02 Table of Contents Index 166-371M
Refer to Figure 81 (which depicts an earlier version of the
meter, without door handle extensions or guards - do not
operate your meters without guards)
10. Open (front) Calibration door
. A small amount of
seed may fall into auger inlet hopper.
Do not open (rear) Clean-Out Door before auger
is operating, or material may flow in large volume
and overflow auger inlet hopper.
11. Check that auger controls are at centre/off.
Refer to Figure 83
12. At Fan/Auger selector valve, select AUGER.
13. Actuate fan/auger hydraulic circuit. The auger does
not operate at this time.
Rotating Auger Hazard:
Use two people for the next steps, to avoid requiring a single
person to be alone and in close proximity to a rotating auger.
Figure 82
Open Calibration Door
26401
2
1
1
2
Figure 83
Fan/Auger Selector Valve
32392
Auger Unload: Hydraulic Circuit Operation
Lift
Fan,
Auger
Fold, Tilt,
Marker
Transport
Hooks
Neutral Extend Neutral Neutral