Great Plains NTA3007 Operator Manual - Manual (Page 5)

2012-07-02 Table of Contents Index 166-371M
Great Plains Manufacturing, Inc. Table of Contents Index 1
Equipment Identification
This Operator manual applies to the following Great
Plains pull-type integrated air drill seeders:
See “Specifications and Capacities” on page 163 for
precise swath information.
Refer to Figure 1
For positive equipment identification, consult the serial
number plate
located on the rear frame cross-member
below and left of fan.
Note: The present manual does not apply to “HD” models
NTA907HD or NTA3007HD. See manual 166-207M
for HD drills.
North American Models NTA3007
Models NTA3007 are built to North American highway
transport standards.
Refer to Figure 2 (which is NOT from an actual machine)
The serial number plate provides the model number and
serial number specific to your machine.
See “Transporting the Air Drill” on page 50
and “Specifications and Capacities” on page 163 for
additional weights and measurements.
Export Models NTA907
Models NTA907 are built to European highway transport
standards.
Refer to Figure 3 (which is NOT from an actual machine)
If you, or the dealer, have added Options not originally
ordered with the machine, or removed Options that were
originally ordered, the weights and measurements no
longer are accurate for your machine. Update the Record
on the next page upon modifications.
NTA907-3610 9m, 36-row, 25.4cm (10in) spacing
NTA907-4875 9m, 48-row, 19.1cm (7.5in) spacing
NTA907-6006 9m, 60-row, 15.0cm (5.9in) spacing
NTA3007-3610 30 foot, 36-row, 10 inch spacing
NTA3007-4875 30 foot, 48-row, 7.5 inch spacing
NTA3007-6006 30 foot, 60-row, 6 (5.9) inch spacing * P 2 * N
Figure 1
Label/Plate Location
32450
1
1
Figure 2: NTA3007:
Example Serial Number Plate
32162
Figure 3: NTA907:
Example Machine Label
32230