Transporting, Warning, Excessive speed hazard – Great Plains TSF1260 Operator Manual User Manual
Page 40

36
TSF1060 and TSF1260
Great Plains Manufacturing, Inc.
500-642M
01/12/2012
Transporting
1.
Position your sprayer in an open area where you will
not hit power lines, buildings, etc. when the boom is
folded.
2.
If transporting empty, do at least fill the hand wash
tank. See “Filling Hand Wash Tank” on page 41.
3.
Check that the tractor is capable of towing the
sprayer. The sprayer must weigh no more than 150%
of the tractor weight. The tractor must be rated for
the load. See table at right for sprayer configurations.
4.
Make sure the safety chain is securely fastened to
the tractor draw bar and the retaining clip is fastened
to the hitch pin.
5.
Never allow riders when transporting the sprayer.
6.
When transporting your sprayer, be sure to watch
the height clearances of your folded boom to prevent
damage to the boom and possible injury.
Contact with electrical power lines can cause death by electro-
cution.
7.
Do not exceed 20 mph (32 kph) while transporting
your sprayer.
8.
Do not transport sprayer while filled with chemical
mixture.
Note: If a suitable water source exists at the field, trans-
port the sprayer with main tank empty. The weight
of the sprayer more than doubles when the main
tank is full.
818 188C Rev C
Do Not exceed 20 mph maximum transport
speed. Loss of vehicle control and/or machine
can result.
To Prevent Serious Injury or Death:
EXCESSIVE SPEED HAZARD
WARNING
Sprayer Configuration
Weight
TSF 1060, Empty
7520 lbs (3411 kg)
TSF 1060, Full
16450 lbs (7462 kg)
TSF 1260, Empty
8070 lbs (3660 kg)
TSF 1260, Full
19075 lbs (8652 kg)