Wheatheart X Series 13 Augers - Manual (Page 81)

W HEATHEART - X13 S ERIES A UGERS 5. P LACEMENT
X1374, X1384, X1394 5.1. P LACEMENT P ROCEDURE
30787 R1 81
5. Placement
Important: Wheels must be free to move when raising or lowering the auger.
Important: Always use a safety chain when transporting the auger.
Note: Do not place anything under the wheels of the auger for added height.
Note: When raising or lowering the auger, the intake hopper must be lifted off the
ground.
5.1. PLACEMENT PROCEDURE
1. Disconnect PTO driveline from tractor and secure in transport saddle.
2. Ensure that tractor and auger are securely hitched together.

Important: Use a type of hitch pin (see Auger / Tractor Hookup section) that will not allow
auger to separate from towing vehicle.
3. Disconnect the safety chain from the hopper.
4. Connect hydraulic hoses, ensure connections are tight. Check for leaks,
binding, flattening, kinks, or wear. Before connecting hose, ensure that the
quick-connect coupler on auger and tractor is clean and free of dirt by wiping
with a cloth.
Note: Because of the many different kinds of tractor hydraulic systems, the quick-
connect coupler must be supplied by the owner. Please consult your tractor
manual or dealer for the proper coupler.
CAUTION
If hose valve remains open, a loss of hydraulic
pressure within the tractor system will allow
the auger to lower inadvertently, damaging
equipment and/or causing personal injury.
NOTICE
When positioning the auger, the PTO driveline must be
disconnected from the tractor and placed in the transport
saddle to prevent damage to auger and PTO driveline.
NOTICE
Replacement hose and hose ends must have a minimum
strength of 2500 psi (17200 kPa) working pressure.