Wheatheart X Series 13 Augers - Manual (Page 29)

W HEATHEART - X13 S ERIES A UGERS 3. A SSEMBLY
X1374, X1384, X1394 3.4. I NSTALL THE B OOT ON THE A UGER TUBE
30787 R1 29
3.4. INSTALL THE BOOT ON THE AUGER TUBE
.\
See Table 3.4. for a list of parts required to install the boot on the auger tube.
Note: The gearbox is sent from the factory filled half way with EP90 gear oil. Before
further assembly, check oil level to make certain the gearbox is half full. Add oil if
necessary. Do not use grease.
1. The boot flighting comes pre installed on the end of the lower tube flighting
shaft (See Figure 3.5). Ensure that the flighting is fastened with a

1/2'' X 4” GR8 bolt and 1/2” locknut before proceeding.
Figure 3.5 Check Boot Flight Bolt and Nut
Table 3.4. Parts Required, Installing the Boot on the Auger Tube
Part Number Description Amount
29991 X13 boot assembly 1
29999 X13 boot-tube attach plate 1
18698 7/16” X 1-1/4” bolts 21
17593 7/16” locknuts 21
WARNING
Components are heavy and create a crushing
hazard if improperly handled. Be sure to use
proper hoisting equipment and procedures,
and ensure lifting apparatus is secure. Lock
out the lifting apparatus before working
around or under the raised components;
failure to do so may cause serious personal
injury.
1/2” LOCKNUT
1/2” X 4” GR8 BOLT