Wheatheart X Series 13 Augers - Manual (Page 61)

W HEATHEART - X13 S ERIES A UGERS 3. A SSEMBLY
X1374, X1384, X1394 3.15. C ONNECTING H YDRAULIC H OSE TO C YLINDERS
30787 R1 61
3.15. CONNECTING HYDRAULIC HOSE TO CYLINDERS
Table 3.13. provides a list of parts required to connect hydraulic hose to the lift
cylinders.
Refer to the Appendix for hydraulic fitting tightening specifications.
1. Remove plugs from the hydraulic cylinder.
2. Install
a steel elbow fitting on the port of either of the two cylinders.
3. Attach steel T fitting to the port on the other cylinder.
4. Connect one end of the short hydraulic hose between one steel T fitting port,
and connect the remaining end to the elbow fitting on the other cylinder.
5. Connect the end of the long hose to the remaining steel T fitting port.
6. Lay the long hose along the upper scissor frame and tube (Figure 3.31).
7. Secure the hydraulic hose along the top of the upper scissor and on the tube
using the welded hose clips.
8. Provide slack or a loop between each secured point.
9. Bend tops of welded clips over slightly to retain hose.
10. Connect ball valve to the boot using the ball valve bracket and two 1/4" x 3/4"
bolts and locknuts (Figure 3.32).
Do not make bends in hydraulic hose too tight. The bends must have a radius of
at least 4” to prevent failure of the hose.
Table 3.13. Parts Required, Connecting Hydraulic Hose to Cylinders
Part Number Description Amount
28480 Steel T 1
28478 Steel elbow 1
20058/20059/20060 X13 hydraulic hose assembly 1
28468 Hose, 3/8'' X 2', 2500 PSI 1
----- Ball valve 1
9900800 1/4” x 3/4” bolt 2
28449 1/4” locknuts 2
Note:
Important: