Wheatheart X Series 13 Augers - Manual (Page 50)

3. A SSEMBLY W HEATHEART - X13 S ERIES A UGERS
3.11. A SSEMBLE THE A UGER F RAME X1374, X1384, X1394
50 30787 R1
1. Ensure the workspace is clear and large enough to accommodate assembly
of the auger.
2. Lower the assembled 3-piece axle to the floor, supported on two 4" blocks
under each side, and positioned so that the lower frame arm flanges face
toward the assembly area.
3. Install frame arms on each side of the 3-piece axle:
a. Position frame arms so that the pin-flange ends are angled toward the
centre of the work area, and position the opposite ends (flanged, with bolt
holes) so that the frame arm flange bolt holes align with the 3-piece axle
bolt holes.
b. Use four 3/4'' x 2'' bolts and 3/4'' locknuts to connect each lower frame arm
to respective axle end flanges.
c. Support the frame arms along their length with 4” blocks.
4. Install the stabilizer cross member (bolt loosely, until tube is dropped into
place) using four 1/2'' x 1-1/2'' bolts and 1/2'' locknuts on each side.
5. Install the scissor rest (bolt loosely, until tube is dropped into place) using

1/2'' x 1-1/2'' bolts and 1/2'' locknuts.
6. Install the transport stand on the 3-piece axle using four 3/8'' x 1-1/4'' bolts
and 3/8'' locknuts for each tube. Ensure that the transport stand is oriented
as shown in the diagram.
WARNING
Components are heavy and create a crushing
and pinching hazard if improperly handled. Be
sure to use proper hoisting equipment and
procedures, and ensure lifting apparatus is
secure. Lockout the lifting apparatus before
working around or under the raised
components. Failure to do so may cause
serious personal injury.