Wheatheart X Series 13 Augers - Manual (Page 60)

3. A SSEMBLY W HEATHEART - X13 S ERIES A UGERS
3.14. A TTACHING THE A UGER T UBE TO THE F RAME X1374, X1384, X1394
60 30787 R1
6. Connect tube to the scissor lift:
e. Adjust the tube height and frame position until the upper frame attach
spacers are aligned with the tube connection flange holes at the top of the
upper scissor arm.
f. Grease the 1-3/4" x18” upper scissor frame attach pin, and insert it through
the upper scissor flange hole (one on either side), through the frame attach
spacer, and then through the frame spacer and upper scissor flange hole
on the opposite side.
g. Secure the upper scissor attach pins with two 5/16” x 2-1/2” roll pins.
h. Lower the scissor lift until it rests lightly on the frame.
Figure 3.28 Connecting Tube to the Scissor Lift
1-3/4” X 18” UPPER SCISSOR
FRAME ATTACH PIN
5/16” X 2-1/2” ROLL PIN
[28584]
FRAME ATTACH SPACER