Wheatheart X Series 13 Augers - Manual (Page 30)

3. A SSEMBLY W HEATHEART - X13 S ERIES A UGERS
3.4. I NSTALL THE B OOT ON THE A UGER TUBE X1374, X1384, X1394
30 30787 R1
2. Slip the boot-tube attach plate over the boot flighting. Position the plate with
flat edge facing up (see Figure 3.6), and fasten with five 7/16” x 1-1/4” GR8
bolts inserted from the boot side of the flange and 7/16” locknuts.
3. Slip the boot assembly over the lower flighting shaft and attach it to the
flange on the lower tube with 14 7/16” x 1-1/4” GR8 bolts and

7/16” locknuts (see Figure 3.6).
Figure 3.6 Installing the Boot on the Auger Tube
4. Insert the remaining boot attach plate bolts, secure with locknuts, and tighten
all flange and boot attach plate nuts fully (do not overtighten).
TUBE FLANGE
BOOT-TUBE
TOP BOOT-TUBE
ATTACH PLATE
BOTTOM BOOT-TUBE ATTACH
PLATE BOLTS (3)
BOLTS (2)
ATTACH PLATE