SARGENT Passport 1000 PG Mortise Locks - Manual (Page 10)

Rosette must
be oriented as
shown
Fig. 5A
Align cylinder groove
with tapped hole, then
tighten set screw to
hold lock cylinder
1. Slide cylinder through the spring and rosette/
collar and screw into lockbody, rotating the
cylinder clockwise.
Cylinder should be flush with rosette/collar.
Note: SARGENT logo must be horizontal
and on the top of the cylinder (Fig. 5B).
2. Secure the cylinder by tightening cylinder
clamp screw located above the deadbolt.
3. Using the key, verify that the key retracts
the latchbolt (and deadbolt).
Position cylinder so that the SARGENT
logo is right-side up.
Correct Incorrect
Fig. 5B
5 - Installation of Cylinder
Note: For proper cylinder/parts orientation see Fig. 5A.
6 - Deadbolt Functions Only (82276 & 82277)
1. Insert alignment tool (supplied) into lock body thumb turn.
2. Slide back plate over tool and make level.
3. Secure back plate to door with two (2) #6 x 3/8” round head
wood screws or #6-32 x 3/8” round head machine screws.
4. Dispose of tool, position thumb turn over back plate
(Fig. 6A) and secure with #6-32 x 1/4” flat head screw.
Note: Thumb turn should cover screw head when
deadbolt is retracted.
Refer to instructions (A5675G) included in package
included with lock.
Fig. 6A
Back Plate
#6 x 3/8” Round Head
Wood Screws
#6-32 x 3/8” Round
Head Machine Screws
#6-32 x 1/4”
Flat Head Screw
Thumb Turn
Fig. 6B Detail
Alignment Tool
10/31/12
A7807C 10
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Passport 1000 PG Mortise Lock