Exide Technologies Section 94.20 - Manual (Page 93)

APPENDIX E
89
COMMUNICATIONS MODULE
ONLINE SUPPLEMENTS
Operating Instructions http://www.ATSeries.net/PDFs/JA0202-04.pdf
Field Installation http://www.ATSeries.net/PDFs/JD5008-00.pdf
INTRODUCTION
Your AT10.1 Microprocessor-controlled Battery Charger features provisions for
an optional Communications Module that allows the user to remotely monitor and
control the unit over a serial connection. This option supports DNP3 Level 2 and
Modbus protocols over RS-232 or RS-485 half-duplex. Industry-standard SCADA
(Supervisory Control And Data Acquisition) systems will be able to control, monitor,
and log the events of the AT10.1 when this option is supplied. Using the
Communications Module, all features of the AT10.1's front instrument panel are
accessible remotely.
The AT Series Communications Module option (p/n EJ5037-0#), installed
within a battery charger, includes the Communications PC Board (A12), a dc power
supply resistor (R29), and an Operating Instructions manual (
JA0102-04 ). The Field
Installation Kit (p/n EJ5037-1#) also includes special instructions ( JD5008-00 ).
Also available are a compatible industry standard modem with interconnection
cable, or a fiber optic modem kit. Finally an Ethernet gateway option for either
Modbus or DNP Level 2 is available. Contact your sales representative to place an
order for the AT Series Battery Charger Communication Module. Refer to the table
below for ordering information.
Description Part No.
Installed Communications Option for 12 Vdc AT10.1 EJ5037-01
Installed Communications Option for 24 Vdc AT10.1 EJ5037-02
Installed Communications Option for 48 Vdc AT10.1 EJ5037-03
Installed Communications Option for 130 Vdc AT10.1 EJ5037-04
Installed Communications Option for AT10-130-006 EJ5037-05
Communications Module Field Kit for 12 Vdc AT10.1
EJ5037-11
Communications Module Field Kit for 24 Vdc AT10.1 EJ5037-12
Communications Module Field Kit for 48 Vdc AT10.1 EJ5037-13
Communications Module Field Kit for 130 Vdc AT10.1 EJ5037-14
Communications Module Field Kit for AT10-130-006 EJ5037-15
Industry Standard Modem w/10ft Cable
EJ5084-00
Industry Standard Modem w/25ft Cable EJ5084-01
Industry Standard Modem w/50ft Cable EJ5084-02
Fiber Optic Modem w/Interface for AT Comm EJ5230-0#
Ethernet Gateway Interface for MODBUS AT Comm EJ5226-0#
Ethernet Gateway Interface for DNP AT Comm EJ5226-1#