Exide Technologies Section 94.20 - Manual (Page 75)

APPENDIX B
71
FIELD INSTALLABLE ACCESSORIES AND OPTIONS
All accessories/options listed below are available in kits for field installation.
Kits contain all parts and hardware with detailed installation instructions. To
order accessories/options, please provide the following information for each kit:
• Model number and serial number of your battery charger
• Factory part number and description, from the table below
• Quantity required
Contact your sales representative to place an order for accessories/options.
Description Kit Part Number
standard DC Output Filtering (per NEMA PE5-1996) see table 3-2
Battery Eliminator Filtering (per NEMA PE5-1996) see table 3-1
Auxiliary Relay PC Board (A5) for standard circuit breakers EI0213-00
Auxiliary Relay PC Board (A5) for med/high AIC circuit breakers EI0213-01
Copper Ground Bus with one (1) box lug for #14-6 AWG EI0195-00
AC Input Lightning Arrestor (VR3) EJ1074-00
Floor Mounting Kit for Style-586/594 Enclosure EI0192-00
Relay Rack Mounting Kit for Style-586/594 Enclosure EI0193-00
NEMA-2 Type Drip Shield Assembly for Style-586/594 Enclosure EI0191-00
NEMA-4/12/13 Type Enclosure for Style-586/594 Enclosure EI0214-##
Cabinet Heater Assembly for Style-586/594 Enclosure EJ1223-00
Padlock for Style-586/594 Enclosure Front Panel Door EI0215-00
Remote Temperature Compensation Probe Assembly (A10) see below
DNP3 Level 2 / Modbus Communications Module see Appendix E
Forced Load Sharing Accessory EJ5126-##
Remote Temperature Compensation Probe
The temperature compensation assembly consists of two (2) components:
1. To order a replacement probe (or puck), request part number EJ5032-00. This
probe is good for all charger output voltages and all battery types.
2. The standard temperature compensation assembly is supplied with a 25ft / 7.6m
interconnection cable. If you need a longer cable, order it from the table below,
which also shows the ordering part number for a complete probe kit.
Temperature Compensation Probe Kits
Cable Length
(feet / m)
Kit Part Number
(includes probe)
Replacement Cable
Part Number
25 / 7.6 EJ5033-00 EJ5011-00
50 / 15.2 EJ5033-01 EJ5011-01
100 / 30.5 EJ5033-02 EJ5011-02
200 / 61.0 EJ5033-03 EJ5011-03
Use a single cable assembly. Do not try to splice cables together to increase the length.