Tweco 100 Ultra-Cut(March 2013) User Manual

Page 3

WARNINGS

Read and understand this entire Manual and your employer’s safety practices before
installing, operating, or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best judge-
ment, the Manufacturer assumes no liability for its use.

Plasma Cutting Power Supply, Ultra-Cut

100

Automated Gas Contol, DFC-3000

Operating Manual No. 0-5132
Published by:
Thermadyne Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711

www.thermal-dynamics.com

Reproduction of this work, in whole or in part, without written per-
mission of the publisher is prohibited.

The publisher does not assume and hereby disclaims any liability to
any party for any loss or damage caused by any error or omission
in this Manual, whether such error results from negligence, acci-
dent, or any other cause.

Licensed under U. S. Patent No. 5,070,227

Publication Date: June 24, 2009
Revision Date: March 13, 2013

Record the following information for Warranty purposes:

Where Purchased: ___________________________________

Purchase Date:______________________________________

Power Supply Serial #:_______________________________

Torch Serial #:_____________________________________