Cisco 7912G - Manual (Page 132)

Appendix A Reference List of Parameters
Configuration Parameters
A-10
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
CfgInterval Number of seconds
between automatic
profile refreshes from
the TFTP server. At the
earliest idle time
following each interval
expiration, the phone
retrieves its profile
using the tftp get
command. Intervals should vary among phones on the network to
prevent simultaneous contact of the TFTP server by many
phones. This value can range from 60 to 4294967295.
This parameter is ignored if UseTftp is 0.
Value type: Integer.
Default value: 3600
Symmetric Key Key for decrypting the
configuration profile
that is downloaded
from the TFTP server. • 0=The configuration profile is not encrypted.
• string=The profile is encrypted with this key.
This parameter is ignored if UseTftp is 0.
Value type: Alphanumeric string, up to 8 characters.
Default value: 0
Dhcp Specifies whether the
phone contacts the
DHCP server to obtain
values for various
network parameters,
including IP address,
router IP address, and
subnet mask. Set to 0 (disable) if you are not using a DHCP server.
Set to 1 (enable) if you are using a DHCP server.
The default setting is 1.
StaticIP Static IP address of the
phone when DHCP is
not used. Enter the assigned IP address for the phone.
This value is ignored when the Dhcp parameter is enabled.
StaticRoute Static IP address of the
network router when
DHCP is not used. Enter the assigned IP address of the network router.
This value is ignored when the Dhcp parameter is enabled.
StaticNetMask Static subnet mask of
the phone when DHCP
is not used. Enter the subnet mask for the phone.
This value is ignored when the Dhcp parameter is enabled.
Table A-4 Network Parameters (continued)
Parameter Description Usage