Tweco A80-A120 CutMaster - Manual (Page 3)

!
WARNING
Read and understand this entire Manual and your employer’s safety practices before install-
ing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judge-
ment, the Manufacturer assumes no liability for its use.
i
Plasma Cutting Power Supply
CutMaster™ A80 SL100SV Torch™ Operating Manual No.: 0-5119
CutMaster™ A120 SL100SV Torch™ Operating Manual No.: 0-5119
Published by:
Victor Technologies, Inc.
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.victorthermaldynamics.com
Copyright 2008, 2009, 2010, 2012 by
Victor Technologies International, Inc.
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is
prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or
damage caused by any error or omission in this Manual, whether such error results from negli-
gence, accident, or any other cause.
Original Publication Date: December 10, 2008
Revision Date: April 9, 2014
Record the following information for Warranty purposes:
Where Purchased:_________________________________________________
Purchase Date:____________________________________________________
Power Supply Serial #:_____________________________________________
Torch Serial #:_____________________________________________________