Tweco A80-A120 CutMaster - Manual (Page 15)

CUTMASTER A80, A120
Manual 0-5119 INTRODUCTION
2-1
2.01 How To Use This Manual
This Owner’s Manual applies to just specification or
part numbers listed on page i.
To ensure safe operation, read the entire manual, in-
cluding the chapter on safety instructions and warn-
ings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular
attention to the information provided under these
headings.
These special annotations are easily recognized as
follows:
NOTE
An operation, procedure, or background infor-
mation which requires additional emphasis or
is helpful in efficient operation of the system.
CAUTION
A procedure which, if not properly followed,
may cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed,
may cause injury to the operator or others in
the operating area.
WARNING
Gives information regarding possible electrical
shock injury. Warnings will be enclosed in a
box such as this.
Additional copies of this manual may be purchased by
contacting Victor Thermal Dynamics at the address and
phone number in your area listed in the inside back
cover of this manual. Include the Owner’s Manual
number and equipment identification numbers.
Electronic copies of this manual can also be download-
ed at no charge in Acrobat PDF format by going to the
Victor Thermal Dynamics web site listed below and
clicking on the Literature link:
http://www.victorthermaldynamics.com
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear
on a data tag attached to the rear panel. Equipment
which does not have a data tag such as torch and cable
assemblies are identified only by the specification or
part number printed on loosely attached card or the
shipping container. Record these numbers on the
bottom of page 1 for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If
there is any damage, notify the carrier immediately to
file a claim. Furnish complete information concerning
damage claims or shipping errors to the location in
your area listed in the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-crate
the unit.
SECTION 2 SYSTEM:
INTRODUCTION