Cisco XR 12404 - Manual (Page 90)

Chapter 3 Installing the Router
Connecting to an AC Power Source
3-25
Cisco XR 12404 Router Installation Guide
OL-13830-02
Step 3 Tighten the captive screws on the PEM faceplate ( Figure 3-18 ).
Figure 3-18 AC PEM
• All electrical connections between the power supply and the backplane are
made automatically when the power supply is fully inserted in the power
supply bay.
Step 4 Locate the AC power cord and remove it from its shipping packaging. Verify that
the AC power cord shipped with the power supply is the correct type for your site.
Note If you have an incorrect type of power cord, contact your service
representative for a replacement.
Step 5 Plug the AC power cord into the AC PEM.
1 AC PEM handle 4 Power cord receptacle
2 On/Off switch 5 LEDs
3 Bail latch 6 Captive screws
INPUT
OK OUTPUT
FAIL
INPUT
100-240V
12A
50/80HZ OUTPUT
OK
66289
4 5 6
1 2 3
todd.book Page 25 Monday, March 16, 2009 2:47 PM