Cisco XR 12404 User Manual
Page 154
Chapter 5 Maintaining the Router
Removing and Replacing an RP or Line Card
5-30
Cisco XR 12404 Router Installation Guide
OL-13830-02
Step 1
Identify the RP or line card to be replaced and write down the following
information:
•
The RP cable connections on the RP.
•
The number and type of RP or line card, so that you will know the location of
the card when you re-install it or the replacement, in the card cage.
•
The network interface cable connection ports, on the RP or line card.
Step 2
On RPs and line cards with multiple ports, start with the left port on the card and
disconnect the interface cable connectors from each of the ports.
Step 3
After all of the interface cables are disconnected, loosen the two captive screws
on the cable-management bracket and pull the bracket away from the card.
Step 4
Loosen the two ejector lever captive screws at each end of the card faceplate.
Step 5
Simultaneously pivot the ejector levers away from each other to unseat the card
from the backplane connector (
).
Figure 5-19
Removing an RP or Line Card from the Card Cage
66243
CONSOLID
ATED SWIT
CH FABRIC
CR
IT
IC
AL
M
AJ
O
R
M
IN
O
R
MBUS
FAIL
ENABLE
ALARM FABRIC
1
0
2
3
40C48/POS-SR-SC
TX
RX
ACTIVE
CARRIER
RX PKT
CLASS 1 LASER PR
ODUCT
LASERPRODUKT DER
KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER DE CLASSE 1
CLEAN
CONNECTOR
WITH ALCO
HOL
WIPES BEFO
RE
CONNECTIN
G
SL
OT
-0
GIGABIT R
OUTE PR
OCESSOR
SL
OT
-1
CO
LL
LIN
K
TX
RX
RJ
-45
MII
RE
SE
T
AU
X
EJ
EC
T
CO
NS
OL
E
todd.book Page 30 Monday, March 16, 2009 2:47 PM