Cisco XR 12404 - Manual (Page 77)

3-12
Cisco XR 12404 Router Installation Guide
OL-13830-02
Chapter 3 Installing the Router
Connecting RP and Line Card Cables
Connecting RP and Line Card Cables
Use the following procedure to connect RP and line card cables to the router.
Step 1 Proceeding from left to right identify the network interface cable that connects to
each card port.
Step 2 Connect the network interface cables:
a. Carefully route the identified cable through the cable-management tray and
over to the card interface port; connect one cable at a time (
Figure 3-8 ).
b. Proceeding from left to right carefully wrap the cables using the velcro straps.
Figure 3-8 RP and Line Card Cable-Management Brackets
OC-12/STM-4 POS
ACTIVE
0 CARRIER RX CELL
ACTIVE 0 CARRIER RX CELL
ACTIVE 0 CARRIER RX CELL
ACTIVE CARRIER RX CELL
57803
OC-12/STM-4 POS
ACTIVE 0 CARRIER RX CELL
ACTIVE
0 CARRIER RX CELL
ACTIVE 0 CARRIER RX CELL
ACTIVE CARRIER RX CELL
Line card
cable management
bracket
Network
interface
cables
Velcro
strap
todd.book Page 12 Monday, March 16, 2009 2:47 PM