Cisco XR 12404 User Manual
Page 161
5-37
Cisco XR 12404 Router Installation Guide
OL-13830-02
Chapter 5 Maintaining the Router
Removing and Replacing a Consolidated Switch Fabric Card
Figure 5-23
Installing a CSF Card (with PRP-3 installed)
Step 4
Slide the CSF half-way out of the slot, then stop.
Step 5
Touching only the metal card carrier, use your free hand to support the bottom of
the CSF and slide the card completely out of the chassis.
•
Always place the CSF directly into an antistatic bag or other ESD-preventive
container.
•
If you plan to return the defective CSF to the factory, repackage it in the
shipping container you received with the replacement card.
Step 6
Set both edges of the CSF carrier into the card slot carrier alignment grooves on
either side of the CSF slot and slide the card halfway into the chassis.
Step 7
Pivot the ejector levers outward away from the faceplate.
Step 8
Slide the card into the CSF slot until the ejector levers make contact with the front
of the card cage, then stop.
Step 9
Pivot the ejector levers toward the faceplate until the connector properly seats in
the backplane.
Step 10
Tighten the two captive screws.
Caution
Do not overtighten the captive screws; over tightening can strip the
threads on the screw or in the insert in the CSF faceplate.
Step 11
Power on the router.
272403
CONSOLID
ATED SWIT
CH FABRIC
CR
IT
IC
AL
M
AJ
O
R
M
IN
O
R
MBUS
FAIL
ENABLE
ALARM FABRIC
1
0
2
3
40C48/POS-S
R-SC
TX
RX
ACTIVE
CARRIER
RX PKT
CLASS 1 LASER PR
ODUCT
LASERPRODUKT DER
KLASSE 1
PRODUIT LASER DE C
LASSE 1
PRODUCTO LASER DE C
LASSE 1
CLEAN
CONNECTOR
WITH ALCOH
OL
WIPES BEF
ORE
CONNECTIN
G
ETH 0
ETH 1
BITS 0 BITS 1
AUX CONSOL
E
DA
TA
LI
NK
DA
TA
LI
NK
AC
T
SIG
AC
T
SI
G
RESET
PERFORMANCE
RP3
UP
todd.book Page 37 Monday, March 16, 2009 2:47 PM