Glyph GPM-216 - Manual (Page 19)

Glyph GPM-216
19
TUNER: Setup
This option allows the frequency scale of the Tuner to be adjusted. In default configuration, the frequency
of the note “A” is 440 cycles per second. Rotating the knob labeled “freq” will adjust what the Tuner utility
identifies as a “TUNED” A. All other notes will be adjusted accordingly.
Set Reverb:
Reverb can be added to the local inputs. The local input signal, with reverb, will be broadcast to the
network for the other GPM units to hear. When this option is selected, the Selector lights will blink in
accordance with how the local inputs are configured on the unit. Each input can be assigned either the
same or a different reverb type. The choices are:
No Reverb
Vocal Plate
Small Room
Small Plate
Small Hall
Slap Chamber
Medium Room
Medium Plate
Medium Hall
Large Room
Large Plate
Large Hall
Configuration
Graphical Configuration Software
The Graphical Configuration software allows you to setup and configure the GPM-216 units from a
computer on the same local network as the GPM-216 units. The configuration software (Setup.exe) must
be installed on a computer running the Windows 2000, XP or Macintosh OS X operating system. You will
need Java software installed on your machine. The GPM Configurator install will also install Java. If you
already have Java installed, uncheck the checkbox specifying Java on the appropriate dialog box during
installation of the GPM Configurator software.
Once the GPM Configurator software is installed, this computer should be connected to the same network
switch as the GPM units and then restarted. It is also necessary to be certain that the computer being used
is set to “Receive an IP address automatically” to ensure proper connectivity to the GPM units.