E-flite RV-9 450 ARF - Manual (Page 7)

7 E-flite RV-9 450 Assembly Manual
 12. Repeat Steps 6 through 11 to install the rudder
control horn. Note that the rudder control horn will
be on the opposite side, away from the elevator
control horn, when installed.
Main Radio Installation
Required Parts
Fuselage assembly Servo with hardware (2)
Receiver Hook and loop material
Required tools
Pin drill Drill bit: 1/16-inch (1.5mm)
Pencil Phillips screwdriver: #1
Scissors Thin CA
 1. Remove the canopy hatch from the fuselage by
lifting up at the rear of the fuselage. A magnet
holds the hatch to the fuselage at the rear. Slide
the hatch rearward to release the pin that holds the
hatch at the front. Set the canopy hatch aside.
 2. Position the elevator servo in the servo tray with
the output of the servo facing the front of aircraft.
Use a pencil to mark the location for the two servo
mounting screws on the servo tray.
 3. Remove the servo from the servo tray. Use a
pin drill and 1/16-inch (1.5mm) drill bit to drill
two holes in the servo tray as marked in the
previous step.