E-flite RV-9 450 ARF - Manual (Page 16)

16 E-flite RV-9 450 Assembly Manual
 24. Repeat Steps 13 through 23 to install the
remaining aileron servo and linkage.
Joining the Wing Panels
Required Parts
Wing panel assembly (left and right)
Wing joiner Wing bolt plate
Wing dowel (2)
Required tools
30-minute epoxy Rubbing alcohol
Mixing stick Mixing cup
Epoxy brush Paper towel
Low-tack tape Medium CA
Felt-tipped pen
Hobby knife with #11 blade
Please read through this section before mixing
any epoxy. You must be able to complete all the
steps before the epoxy begine to cure or you may
end up with a wing that will require replacing.
 1. Locate the aluminum wing joiner. Slide the joiner
into one of the wing panels.
 2. Slide the remaining wing panel on the wing
joiner. It should slide up tight against the first wing
panel with no gaps between them.
 3. Separate the wing panels. Mix 1/2 ounce
(15mL) of 30-minute epoxy. Use a mixing stick to
apply epoxy in the wing tube of one wing panel.
Slide the joiner into the tube.