E-flite RV-9 450 ARF - Manual (Page 12)

12 E-flite RV-9 450 Assembly Manual
 2. Plug the aileron servos into the Y-harness. Use
the radio system to center the servos. Use a #00
Phillips servo to install the servo horns back on
the aileron servos. Prepare a right and left aileron
servo at this time as shown.
 3. Place the servo on the aileron servo cover. Align
the servo horn with the edge of the cover as shown
in the first photo. The horn should also be centered
in the notch as shown in the second photo. Once
positioned, make sure the servo is not hanging
over the edge of the cover at the front or rear.
Use a pencil to mark the location of the two servo
mounting tabs on the servo cover.
 4. Use medium grit sandpaper to scuff the two
servo mounting blocks as shown. This allows a
better bonding surface when gluing them to the
servo cover.
 5. Use medium CA to glue the two blocks to the
servo cover as shown.