E-flite RV-9 450 ARF - Manual (Page 28)

28 E-flite RV-9 450 Assembly Manual
 7. Repeat Steps 1 though 6 to install the remaining
wheel and wheel pant.
Canopy Detail Installation
Required Parts
Fuselage assembly Canopy hatch
Canopy Seat back (2)
Pilot (optional) (EFLA156)
Required tools
Canopy glue Waxed paper
Medium CA Low-tack tape
 1. Locate the two seat backs. Use medium CA to
glue the seat backs to the canopy hatch as shown
in the photo below.
 2. Use medium CA to glue the pilot (optional) to
the canopy hatch as shown.
 3. Place the canopy hatch on the fuselage. Make
sure to place a piece of waxed paper or part of a
bag from the packaging of your model between the
hatch and fuselage so when the canopy is glued
to the hatch it won’t accidentally be glued to the
fuselage. Make sure that the hatch is fully seated on
the fuselage and the magnet in engaged during this
step. If it is not seated and engaged it could cause
your hatch to fit improperly or not engage once the
canopy is glued on.