E-flite Divo 3D - Manual (Page 4)

4 E-flite Divo 3D Profile Assembly Manual
Important Information About
Motor Selection
We recommend the E-flite ® Park 300 Brushless Outrunner,
1380Kv (EFLM1150) to provide you with lightweight 3D
performance, or the Cyclon Micro Brushless Outrunner ,
1480Kv (CYLCPLR05) for slightly more torque and performance.
Outrunner Setup (E-flite)
EFLM1150 Park 300 Brushless Outrunner Motor, 1380Kv
EFLA1010 10-Amp Pro Brushless ESC
APC09038SF 9x3.8 Slow Flyer Prop
THP7303SJPL 730mAh 3-Cell 11.1V Li-Po, JST
EFLC3005 Celectra™ 1–3 Cell Li-Po Charger
Outrunner Setup (Cyclon)
CYLCPLR05 Cyclon Micro Brushless Outrunner Motor, 1480Kv
EFLA1010 10-Amp Pro Brushless ESC
APC09038SF 9x3.8 Slow Flyer Prop
THP7303SJPL 730mAh 3-Cell 11.1V Li-Po, JST
EFLC3005 Celectra™ 1–3 Cell Li-Po Charger
Or
THP4803SJPL 480mAh 3-Cell 11.1V Li-Po, JST
Note: The use of the Thunder Power 480mAh pack and
Cyclon motor will offer a lighter weight set up. Use
caution as wide open throttle will discharge the battery
at a very high rate. Proper throttle management is
required to achieve optimum performance and prevent
shortened battery life.
Optional Accessories
EFLA110 Power Meter
Required Tools and Adhesives
Tools & Equipment
EFLA250 Park Flyer Tool Assortment, 5-piece
Or Purchase Separately
EFLA257 Screwdriver, #0 Phillips (or included with
EFLA250)
Foam-safe CA
Foam-safe CA activator
Pin drill
Drill bit: 1/16-inch (1.5mm)
6-minute epoxy
Hot glue gun
Low-temperature hot glue
Felt-tipped pen
Paper towels
Hobby knife (#11 blade)
Small round file
Ruler
Square
Low-tack masking tape