E-flite Divo 3D - Manual (Page 12)

12 E-flite Divo 3D Profile Assembly Manual
Wing Assembly
Required Parts
Fuselage assembly Micro control connector (2)
Top wing Top wing control horn (2)
Bottom wing Bottom wing control horn (2)
Cabane strut (2)
Micro control connector backplate (2)
Required Tools and Adhesives
Foam-safe CA Square
Foam-safe CA activator
 1. Place a piece of waxed paper onto your work surface.
With the top of the bottom wing resting on the waxed
paper, use foam-safe CA to glue the bottom wing control
horns to the ailerons. The horns will be flush with the top
of the bottom ailerons.
 2. Install the micro control connectors into the top wing
control horns. Secure them using the micro control
connector backplates. Prepare both horns at this time.
 3. Place a piece of waxed paper onto your work surface.
With the top of the top wing resting on the waxed paper,
use foam-safe CA to glue the top wing control horns to
the ailerons. The horns will be flush with the top of the
top ailerons.