E-flite Divo 3D - Manual (Page 15)

15 E-flite Divo 3D Profile Assembly Manual
 2. Use the 12.8-inch (325mm )carbon rods to install the
cross bracing between the fuselage, top wing, bottom
wing and cabane struts. Position the carbon rods so there
is an equal amount of carbon rod extending beyond the
top of the top wing and from the bottom of the bottom
wing. Use foam-safe CA to glue the carbon rods in
position. Glue the three rods together where they cross
each other as well.
 3. Use the 5.1-inch (130mm) carbon rod to go
between the cabane strut and bottom wing, and the
5.4-inch (137mm) carbon rod between the cabane
strut and top wing.
 4. Install the final 5.4-inch (137mm) carbon rods
between the vertical fuselage and top wing using foam-
safe CA.